Make reusable cable ties from hook-and-loop tape
Cut reusable hook-and-loop ties for spare charging and data cables. Size each tie to a loose coil so the connectors stay visible and the cable unrolls easily.
- Estimated time
- 15 min
- Skill level
- Beginner
Before you start
This is for spare cables you can unplug and store. Lay each one out and let it settle into its natural curve. Choose soft tape that fastens to itself and test that the hook side will face away from any delicate cable cover.
Tools and materials
- Double-sided hook-and-loop tape
- Scissors
- Ruler
Step-by-step instructions
Sort the cables
Unplug the cables and group them by type or device.
Make loose coils
Loop each cable without forcing sharp bends. Leave both connectors visible so you can identify the cable later.
Cut a tie to length
Wrap the tape around a coil and allow a few centimetres for overlap. Mark that length and cut the strip with scissors.
Fasten and check
Press the overlapping ends together. Check that the tie holds when lifted and can be undone without pulling on the cable.
Check the result
Pick up a bundled cable by the coil and put it down again. The tie should hold without pinching or leaving a dent. Open it using the overlap and check that the connectors stay easy to identify.
Troubleshooting
If the cable keeps its kink after you unfasten the tie, make a wider coil and cut a longer strip.