Cut a removable cupboard shelf liner
Measure and cut a non-adhesive liner for a kitchen cupboard. Make room around shelf supports and trim the liner so it lies flat and lifts out.
- Estimated time
- 20 min
- Skill level
- Beginner
Before you start
Use a removable liner suited to the shelf finish and what you store on it. If the shelf is an awkward shape, make a paper template first. Place a pencil mark on the template for the front edge so you can transfer it the right way round.
Tools and materials
- Non-adhesive shelf liner
- Tape measure and ruler
- Pencil and scissors
- Scrap paper for an irregular shelf
Step-by-step instructions
Empty and clean the shelf
Remove everything, wipe the surface and let it dry.
Measure inside the cupboard
Check width and depth at more than one point. Use the smaller measurements if the sides are uneven.
Mark and cut
Mark the dimensions on the back of the liner. Cut along a straightedge guide and trim around any shelf supports.
Test the fit
Lay it flat, trim any edges that curl up and check the door closes before restocking.
Check the result
Open and close the cupboard with the liner in place. Lift a front corner to make sure you can take it out for cleaning. After restocking, slide one item forward to check the liner stays flat beneath it.
Troubleshooting
If the liner slips, check which side the manufacturer specifies should face the shelf.